Service manual

12 TTPM2 Operators’ Guide October, 01
Next clean the roller attached to the brass gear used above:
• Turn the printer off, open the lid, and lift the printhead.
CAUTION! – The printhead is sensitive to scratches and static electricity. NEVER use
tools of any kind against the printhead.
Figure 11. Cleaning the drive belts.
• Insert the Cardclene under the clear plastic flap below the printhead and manually
rotate the brass cogwheel so that the leading edge of the cleaning card passes the
roller, see photograph on the right.
• Hold the card with your right hand whilst rotating the brass cogwheel a couple of full
times.
• Remove the Cardclene and lower the printhead
• Lower the printhead to normal position.
• Close the lid and turn the printer on.
• Wipe of the outside surfaces of the printer.
• Load tickets.
• Make a test printout to see that the printer functions correctly.
• If you used the self-test to do the test printout, turn OFF and ON the printer after-
wards, and the printer is ready for another week of hard work!
The printer is now ready for use.