Service manual

October, 01 TTPM2 Operators’ Guide 11
Figure 9. Blow the dust from the sensors.
• Raise the lid, and using the air duster, point the nozzle at each of the 5 visible sen-
sors see photograph above and blow very briefly.
Next clean the rollers that are indicated in the below photo:
Figure 10. Clean the rubber rollers.
• Close the lid, insert ticket stock into the rear hopper, turn the printer on and a ticket will be
fed into the machine.
• Turn the printer off and lift the lid.
• Place the Cardclene onto the indicated rollers using only a slight amount of pressure,
and manually (with your thumb as shown in the photograph on the right) turn the
brass gear so that the ticket is fed forwards and the rollers are rotated. The pressure
applied to the Cardclene will clean the necessary rollers.
• Close the lid and turn the printer on. The ticket will be ejected and another will take its
place.