Service manual

10 TTPM2 Operators’ Guide October, 01
3.2 Weekly (performed by trained operator or handyman)
This should be carried out Weekly in high print-volume environment and Monthly in low
and medium volume environments
• Remove ticket stock.
• Eject ticket from inside the printer by pressing the button next to the green light.
Figure 8. Inserting a cleaning card in rear ticket entry and pressing it firmly.
• On all printers: Push the Cardclene into the Slot A as in photograph above left, and
the card will be taken into the printer which will stop feeding when only 5mm is show-
ing.
Press firmly down onto the card with your thumb as in photograph above right and
press the button next to the green light. After 5 seconds lift your thumb to release the
Cardclene and it will be ejected through the front slot.
• On front load printers: Holding the last 5mm of the Cardclene firmly, insert it into the
front hopper and issue a “load ticket from front”-command !L3.
The printer will try and pull the card in, but if you hold onto it firmly enough so that all
but the last 5mm is pulled in, it will give an error after approx. 5 seconds, and the ap-
propriate roller will have been cleaned. Turn off and on the printer to remove the
Cardclene.
• On CD-200 versions: Insert the Cardclene into the empty card dispenser and place
the weight on top of it.
Turn the printer off and on and after approx. 20 seconds the cleaning process will
stop.
Remove the card and turn the printer off.