Specifications

Firmware History

Ticket Dimensions and Perforation

P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009

4.40

Problem found which could cause trailing ticket to be fed to long after cut-

ter. Fixed.

!O n implemented. n=1 results in 512 bits read from track 1. . n=3 results

in 512 bits read from track 3. Any other value including none gives the

standard !O reply.

Possibility to change start & end frequency on encoding motor (command

!F A … … 1), and on the printing motor (command !F A … … 2),and new

default parameters for speed.

Code 128 and EAN 128 added.

4.55 PIO Timing changed back

4.61 The possibility to reset after a critical error has been removed because it

caused problems when printing many small bitmaps.

4.64 When reading track 3, the string was only terminated with an LF. This is

now corrected to CR/LF as it is on the other tracks.

4.70 Stepper motor for encoding now runs half-steps instead of full steps. This

gives a smoother ride and improves encoding reliability

a. Some control boards using NEC PIO dated 0213 LDW02 may not start with versions 4.22 to 4.54

Version

Change