Specifications

Firmware History
Ticket Dimensions and Perforation
92
P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009
FW
Version
Change
3.20 Added commands !Q, !U, !V, and !N+.
New magnetic encoding attributes added
Only dual entry version:
Does not accept ticket data
without entry selection command. !L1, !L2,
!L17, or !L18 must always be sent prior to every !P command. Signals
NAK 1 to indicate error and discards the received data.
Restrictions Same as 906-290
3.30 !F T modified with fixed spacing setting for font 1.
New commands !Q, !U, !V and !N+
New error message NAK X
Added power ON ticket detection routine that voids any ticket left in the
printer at power OFF.
An ”ETX” (03H) is issued when the print cycle is completed.
Restrictions Same as 906-290
3.32 !W print progress indication command added, and improvements to the
power failure cleanup.
3.50 Only barcodes of size 1 and 2 printed in east and west orientation will
reduce print speed.
Restrictions Same as 906-290
3.60 !Y “read ticket counter” command added
Restrictions Same as 906-290
3.70 Characters added to positions 128 to 255 of fonts 1 and 4. Among them
is the Euro symbol ( € ) in position 128. See Technical Specifications
Manual for complete character set.
Restrictions Same as 906-290
3.80 A ticket inserted in the rear upper slot before the TTPM2 has received a
load command causes the red LED to start flashing and the TTPM2 waits
for the ticket to be removed before continuing.
To prevent a ticket that has been left sitting at the mouthpiece from being
sucked in when a front load command (!L3) is received, the TTPM2 now
senses if there is a ticket already in the mouthpiece when the !L3 is
received and in that case it flashes the red LED until the ticket has been
removed.
Restrictions Same as 906-290