Specifications

Command Reference
Document-Entry Related Commands
42
P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009
Same function as !L1, but when ticket loading fails the printer sends an error code (NAK + '1')
instead of waiting for paper to be loaded. It is then up to the system to determine if paper
should be loaded from the upper document entry instead.
Same function as !L2, but when ticket loading fails the printer sends an error code (NAK + '1').
It is then up to the system to determine if paper should be loaded from the lower document
entry instead.
!T@nn
nn is the delay in seconds
When a ticket is left in the output of the front load after the timeout nn has expired, NAK F is
sent to the host controller to indicate that the ticket hasn't been picked up.
If the customer takes the ticket before the timeout elapses, the printer sends a Bel (07H)
character.
@ Expands the signaling: If you have a Front load with waste basket function, the printer
retracts the uncollected ticket and ejects it into the wastebasket exit.
Both examples above sends BEL if the ticket is taken
!L17
Select lower rear document entry and signal paper out (only dual
entry printers)
!L18
Select upper, rear document entry and signal paper out (only dual
entry printers)
!T Sets timeout for retract function (only printers w. waste bin
a
)
a. Introduced in firmware version 3.75
Note •
The !T command should be sent after the !P (print) command. DIP-switch 6 must be
ON for status replies to be sent.
Example •
!P
!T @20
Retracts the ticket and sends NAK F if it has not been taken within 20 seconds
Example •
!P
!T 20
Sends NAK F if the ticket if it has not been taken within 20 seconds