Specifications

Command Reference

Document-Entry Related Commands

P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009

Document-Entry Related Commands

This command sets the ticket length if paper without gaps or black marks is used. One step is

0.7mm.

The mechanics of TTPM 2 works with ticket lengths between 54 and 120 mm.

This command ejects, through the rear document entry, any document positioned in the active

position for encoding (or after decoding). See Single-Ticket Handling on page 71 for the

definition of active/ standby ticket position.

Selects lower rear document-entry and feed the leading document, in the consecutive supply

entry, to active position. If, in the preceding operation, the upper rear document entry has been

engaged, the document in that entry is retracted from the active position.

Note that DIP switch no. 6 must be set to ON to enable the ACK/NAK signaling.

See alternative command !L17.

Same function as !L1, but selects upper rear document entry.

See alternative command !L18.

!A Set ticket length for roll paper

a. This command was introduced in firmware version 4.55

!A 127 sets up a credit car sized ticket length.

!A 0 turns off the function and reverts to gapped ticket stock. This is the default

setting.

E Eject through rear document entry

!L1 Select lower rear document entry (dual entry printers only)

Note • On dual document entry printers, a ”select rear entry” command (!L1, !L2, !L17 or

!L18) must precede the print command (!P). An ACK character is returned if the command

was successful. If no paper is present, the yellow indicator lights up and the printer waits

until the operator insert new paper stock.

!L2 Select upper rear document entry (dual entry printers only)