Specifications

39
Command Reference
System Related Commands
03/05/2009 TTPM2™ Installation and Programming Manual P1003645-001
!F A N <start freq> <top speed> <motor> 1 1 1_”remark”
!F Command to load print-parameter information.
A Indicates acceleration and speed mode.
N Print orientation. This is ignored in acceleration and speed mode.
Orientation is always North (N). The printer requires the N to be inserted.
<start freq> Start frequency. Set the base frequency from where the acceleration starts. A
value of 30 indicates a start frequency of 300 Hz.
Top speed Top speed is the frequency at which the acceleration stops. A value of 450
sets top speed to 4500 Hz.
motor “1” selects encoding motor, while “2” selects print motor
1 Not used. Must be set to 1.
1 Not used. Must be set to 1.
1 Not used for graphics printing. Must be set to 1.
space One space has to follow the "1" before the graphics data.
Remark Here you can enter a remark describing the setting you just did. It will not be
printed.
Example •
!C<CR><LF>
!F A N 30 250 1 1 1 1 "Encode speed (full-step)"<CR><LF>
!F A N 30 190 2 1 1 1 "Print speed (half-step)"<CR><LF>
!P<CR><LF>