Specifications

Command Reference
System Related Commands
38
P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009
The TTPM2 responds by sending the same 1 byte response to the host computer as is sent as
byte 1 in response to the !S command. The ENQ command is effected immediately after
receipt, whereas the !S command is effected in sequence when received.
TTPM2 has two feed motors, one for encoding and one for printing.
This command sets the start-frequency and the top speed of each motor.
Syntax for defining and downloading graphics data is as follows:
ENQ Status request, immediate
!F A Feed- acceleration and speed
a
a. This command was introduced in firmware version 4.49d
Note • This command should not be used! Suitable speed is selected by Zebra and set as
default parameters in the firmware. The speed setting has to reflect the motors fitted in the
printer and the mechanical buildup of the printer. A single unit may be tunable to a higher
speed but it is not certain that the settings work on the next printer.
Note • A three-button reset will set the values to factory default.