Specifications

Command Reference

System Related Commands

P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009

Encoding Retries

Adding a single digit after the !P makes it possible to set the maximum number of encoding

retries for one ticket. The number given is the number of additional tries i.e. !P 1 means one

normal attempt plus one retry. Default is 1, which is the value used if no digit is present.

Eject to Waste Basket

Adding an @ character (!P@) makes the printer eject the completed ticket into wastebasket

(for FL2 and FL3 printers). One use for this can be to make status printouts that are not

intended for the customer.

Eject Fully

Adding an E (!PE) makes the printer eject the ticket fully so that it can fall down into a tray

(for FL3 printers)

Digits and @, or digits and E can be mixed on the same line, for example !P5@ makes five

encoding retries, and ejects the ticket into the wastebasket.

Set Print Speed

Adding letters S, M, or F adjust the print speed:

Print quality is very much dependent on speed. The normal print speed is used unless you

select Fast or Slow with this command.

!Q writes a string with up to 15 ASCII characters to a buffer memory in the printer.

Example: !Q asdfgh <CR><LF>

After the ticket has been correctly encoded/printed, the string is copied to a buffer in the

battery backed up RAM. This buffer can be read by the !V-command.

The transaction string is committed at the precise point where a useable ticket has been

produced. The only way to reset a transaction string is to successfully print another useable

ticket that was initiated with !Q. Loss of power or a reset or any other instruction leaves the