Specifications
31
Command Set
Summary of Commands
03/05/2009 TTPM2™ Installation and Programming Manual P1003645-001
Document Entry Commands
Print-Parameter Commands
!A Sets ticket length for roll ticket without blackmarks
a
a. Introduced in firmware version 4.55.
page 40
!E Ejects document through the upper rear document entry (for example after
decoding)
page 40
!L1 Selects lower rear document entry, and waits if paper is out (for units with
dual consecutive entries
b
)
b. !L1, !L2, !L17 or !L18 must be selected on units with dual document entries.
page 40
!L2 Selects upper rear document entry, and waits if paper is out (for units with
dual consecutive entries)
page 40
!L3 Loads document through front entry page 41
!L4 Ejects document through front entry page 41
!L5 Transports document to waste bin (only for printers with front load 2 and
3)
page 41
!L17 Selects lower rear document entry and signals if paper is out (for units
with dual consecutive entries
c
)
c. Both the 5 V and 24 V ground, as well as the chassis of the printer, must be connected to
ground potential (safety ground).
page 42
!L18 Selects upper rear document entry and signals if paper is out (for units
with dual consecutive entries
c
)
page 42
!T Sets timeout for retract function
d
d. Introduced in firmware version 3.75.
page 42
Note • Make sure not to print data outside this area when you use the !F command.
If you do, you write in parts of the memory that are used for other functions in the printer,
and the result is totally unpredictable.
Note • Both the 5 V and 24 V ground, as well as the chassis of the printer, must be connected
to ground potential (safety ground).
!F T Print text page 43
!F G Print graphics page 45
!F C Print bar code page 47
!F M Specifies No. of retries + cancellation text to be printed if encoding fails page 49