Specifications

Command Set
Syntax
24
P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009
Syntax
A command string always starts with an exclamation mark (ASCII 33 or HEX 21) serving as
command identifier. The exclamation mark must be at the first position of the line, that is,
directly after a CR LF. Otherwise it will not be recognizes as command identifier.
The characters immediately following the “!” (21H) form the actual command to the printer.
The command consists of 1–3 characters and is followed, when applicable, by a sub command,
formatting commands, and data separated by space characters as shown in Figure 15.
A Carriage Return and Line Feed end each command.
Figure 15 • Command Syntax
Command identifier
Command (1 to 3 characters)
Sub command
Formatting commands
separated by spaces
Data enclosed in
quotation marks
Space character
(ASCII 32 or HEX 20)
Only used with some commands
Graphical data starts directly without any quotation mark
and ends after the specified number of bytes
New line = CR LF
(ASCII 13 10
or HEX 0D 0A)
SW97119
1
1
1
2
2
1