Specifications

03/05/2009 TTPM2™ Installation and Programming Manual P1003645-001
3
Operation
Operator Controls
Figure 9 • Indicators and pushbuttons
General Reset
A general reset of the TTPM2, restoring all parameters to their default value, is effectuated if
all three pushbuttons are kept depressed at power ON. All three indicators will light but
nothing else will happen. At this point, the power has to be turned OFF and ON once more.
The TTPM2 is then reset.
Green indicator
Fixed:
Blinking:
Flickering:
Temporarily OFF:
Power ON & printer ready.
Insert ticket.
Receiving data.
Commands are executed.
Yellow Indicator
Fixed: Out of paper.
Blinking: Print command
received, but out of paper.
Red indicator
Error, turn OFF
and ON the printer
to clear.
Front pushbutton
1.Cuts and ejects a ticket .
2. Press and hold at power ON to enter
self test mode. Press again to encode
and print one ticket. The printout
shows current firmware version. Turn
printer OFF and ON to exit self test
mode.
Center pushbutton
1. Ejects any document in
the selected ticket track.
(Same as when an !E
command is received.)
2. Press and hold at power
ON to run cleaning card
through printer.
Rear pushbutton
Press and hold at power ON to turn on paper
jam clearing mode. Press front button to
advance ticket forward and middle button to
retract ticket backwards. Turn printer OFF
and ON to exit paper jam clearing mode.
SW97108
1
2