Specifications

13
Installation
Installing an OEM Printer Mechanism
03/05/2009 TTPM2™ Installation and Programming Manual P1003645-001
Figure 5 • Power supply connector pin assignment
After fastening the printer, proceed with Introduction on page 7.
Note • Both the 5 V and 24 V ground, as well as the chassis of the printer, must be connected
to ground potential (safety ground).
Caution • If you do not use a non Zebra Power supply, the one you use must have the
correct timing; 5 V must be on and stable in advance of 24 V at power on, and remain on
until after 24 V disappears at power off.