Specifications

Installation
Installing a Desktop Printer
10
P1003645-001 TTPM2™ Installation and Programming Manual 03/05/2009
Figure 2 • Rear view, desktop printer, and OEM printer mechanism
Installing a Desktop Printer
1. Verify that the supply voltage range stated on the type plate is suitable for your local line
voltage.
2. Connect the printer to a line outlet with safety ground.
The ground potential should be the same as for the host computer. If ground potentials
differ, use a short distance modem between the computer and the printer.
3. Clear the memory of the printer by making a general reset (hold down all three buttons
while turning ON the printer, then turning it OFF again).
4. Turn on the printer.
The green indicator should light up.
5. Press the front button.
The green indicator starts flashing and the yellow indicator lights up, indicating ”Out of
Paper”.
6. Turn the tickets so that the magnetic stripe is on the left side facing downwards, as seen
from the front of the printer.
7. Insert tickets in the lower document entry. The printer feeds the tickets forward and cuts
and ejects one ticket.
8. Turn off the host computer and the printer.
9. Connect a serial cable between the COM port of the host computer and the serial input of
the TTPM2 printer.
The printer is ready for use.
Upper document entry
Lower
document entry
Power ON/OFF
switch
Fuse
holder
Power
cable
receptacle
Power connector
RS 232 interface connector
SW95065D