Declaration of Conformity

TC26EK Regulatory Guide
4
For devices that utilize a USB port as a charging source, the device shall only be connected to products
that bear the USB-IF logo or have completed the USB-IF compliance program.
Do not disassemble or open, crush, bend or deform, puncture, or shred. Damaged or modified batteries
may exhibit unpredictable behavior resulting in fire, explosion, or risk of injury.
Severe impact from dropping any battery-operated device on a hard surface could cause the battery to
overheat.
Do not short circuit a battery or allow metallic or conductive objects to contact the battery terminals.
Do not modify, disassemble, or remanufacture, attempt to insert foreign objects into the battery, immerse
or expose to water, rain, snow or other liquids, or expose to fire, explosion, or other hazard.
Do not leave or store the equipment in or near areas that might get very hot, such as in a parked vehicle or
near a radiator or other heat source. Do not place battery into a microwave oven or dryer.
To reduce the risk of injury, close supervision is necessary when used near children.
Please follow local regulations to promptly dispose of used re-chargeable batteries.
Do not dispose of batteries in fire. Exposure to temperatures over 100°C (212°F) may cause explosion.
Seek medical advice immediately if a battery has been swallowed.
In the event of a battery leak, do not allow the liquid to come in contact with the skin or eyes. If contact has
been made, wash the affected area with large amounts of water and seek medical advice.
If you suspect damage to your equipment or battery, contact Zebra support to arrange for inspection.
Waste Electrical and Electronic Equipment (WEEE)
For EU Customers: For products at the end of their life, please refer to recycling/disposal advice at:
www.zebra.com/weee.
MN-004127-01ENa_tc26ek-rg-en.book Page 4 Wednesday, January 27, 2021 7:51 AM
Draft v4