Owner`s manual

English

Press the CH/ key to enter the channel setting. Press

OK then press the or key to select the Auto Channel

Change settings or Manual Channel Change settings.

The Display shows the following:

Press the CH/ key to enter each setting.

Note:Pressing the CH/ key will go back to idle

status.

Auto Channel Change setting

Press the CH/ key to enter Group Mode.

Press OK to set the Auto Channel change and the display

will show the current group number. Press OK then press

the or key to select the group channel number press

again the or key to select the group mode in "ALL".

Press OK to confirm and transmit Auto Channel change

command.

Note:Pressing CH/ key will go back to idle status.

Manual Channel setting

Press the CH/ key to enter Group Mode. Press OK to

set the Manual Channel setting and the display will show

"MY".

Press OK then press the or key to select the

channel.

Then, Manual channel setting is available.

Note:Pressing the CH/ key will go back to idle

status.

Set All/Direct Call

Press the / key in Group mode to enter All/Direct call

setting. At first the user selects a type of call from All Call

transmission or Direct Call setting.

To select the setting, press the or key to select the

type of a call.

Set All Call

When All Call Transmission " ZYNC" is selected press the

/ key to transmit All Call immediately. Then it sounds

All Call tone to the receiver unit. The display shows TX icon

and Call icon while transmitting.

Note:Pressing the CH/ key will go back to idle status.

Auto Channel

Change

Manual Channel

Change

All Call

Transmission

Direct Call

Transmission

T8_EN.fm Page 16 Thursday, September 16, 2010 12:01 PM