User`s manual

232
Chapter 3
Translation Tbl (TN5250, Twinax)
Prints a table of the twinax interface’s current character set. This operation is
valid only when the twinax interface is the current interface.
True Vert 1/10
• Disable (the default). When disabled and in High Resolution, a vertical
line’s length in one inch and 1/10 inch increments is interpreted as 70/72
inch and 7/72 inch respectively.
• Enable. When enabled, a vertical line’s length is interpreted exactly,
which is 72/72 inch in one inch increments.
Trunc Dyn Data
This submenu allows the user to truncate the dynamic data up to the
maximum data length specified in Create Mode.
• Disable (the default). If the dynamic data exceeds the maximum data
length, an error will report.
• Enable. If the dynamic data exceeds the maximum data length, the data
truncates.
Truncate Alpha
• Enable (the default). Prevents the printing of Error 48 (Element Off Page
Error) if alphanumeric data, including spaces, extends beyond the right
side of the form.
• Disable.
Twinax Type
This parameter defines the printer emulation as follows:
• IPDS 256 Bytes (the default)
• IPDS 1024 Bytes
• 5225
• 4234
After the emulation has been changed, a POR status is sent to the host.
Typeface
• Letter Gothic (the default). Letter Gothic is a non-proportional font where
all of the characters take up the same amount of space when printed.
• Courier. Courier is a non-proportional (monospaced) font where all
characters take up the same amount of space when printed.
• OCR-A / OCR-B. Optical character recognition fonts printing at 120 dpi
horizontally and 144 dpi vertically. Both fonts print only at 10 cpi.