Technical information
The Cutter Module requires periodic cleaning to remove paper dust and gummed
label residue. The procedure on the following pages should be performed by the
operator according to the schedule on page 4-9. However, depending on your
application and media type you may need to clean the cutter more or less
frequently.
NOTE: In the figures shown, media and ribbon have been removed for clarity. It is not
necessary to remove media or ribbon prior to performing the maintenance
procedures described.
NOTE: Do not exchange Cutter Modules between different printers. The Cutter Module
adjustments are optimized during installation to work with a particular printer,
and may not perform correctly if they are placed on a different printer.
44868L Page 4-3