Reference guide

Quick Reference Guide 9
Vertical Mount
To mount the cradle on a vertical surface:
1. Use a Phillips screwdriver to turn the Wall Mount Conversion Dial to the correct
position for a vertical (wall) mount (see Features on page 5). The front latches
protract to engage the depressions at the base of the scanner’s handle.
2. Use a Phillips screwdriver to remove the screws on the back of the cradle as
pictured and follow the steps below to install the wall cup.
3. Attach the interface and power cables to the appropriate ports (see
Connections).
4. Press the cables into the cable grooves.
5. Mark the surface on which to mount the cradle using the mounting template in
the MT2070/MT2090 User Guide to determine the location of the screw holes.
6. Pre-drill holes to accommodate two screws.
7. Attach the cradle securely to the surface.
8. Place the scanner in the cradle.
Use fingers to squeeze cup release
snaps while pulling out desk cup.
Desk Cup
Wall Cup
1 2
3
4 5