Reference guide

8 STB20XX Single Slot Cradles
Changing the Host Interface
To connect to a different host, or to the same host through a different cable:
1. Unplug the power supply from the cradle.
2. Unplug the interface cable from the host.
3. Connect the interface cable to the new host, or the new interface cable to the
existing host.
4. Reconnect the power supply, if required.
5. If necessary, scan the appropriate host bar code (for non-autodetected
interfaces). Refer to the User Guide.
Mounting the Cradle
Horizontal Mount
1. The cradle is packaged with the horizontal mount desk cup installed (see
Features on page 5). If it was replaced with the wall cup, remove the wall cup
and reattach the desk cup.
2. Use a Phillips screwdriver to turn the Wall Mount Conversion Dial to the correct
position for a desktop/horizontal mount (see Features on page 5).
3. Attach the appropriate cables.
4. Place the cradle on the desk to and insert the scanner.
CAUTION
If the scanner does not recognize the host, disconnect the power
supply, then reconnect after connecting the host cable.