Reference guide

Quick Reference Guide 7
Connections
Connections vary by cradle configuration. The STB2000 and STB2000-F cradles
are charge only cradles. The host interface port can only be used to connect a
USB cable to a PC for an ActiveSync connection.
1. Insert the USB or host interface cable into the cradle’s USB/host port.
2. Connect the other end of the cable to the PC.
3. Connect the appropriate cable to the power supply and an AC power source, if
necessary.
4. Optional: Insert the power supply cable ferrite into the support features on the
cradle bottom and run the host and power cables into their respective cable
grooves.
For forklift cradles, if cables are not thread into their respective cable grooves,
it is recommended to use cable ties to secure cables to the mounting plate
after it is attached to the cradle (see Mounting the STB2000-F on the Forklift).
5. If necessary, scan the appropriate host bar code (for non-autodetected
interfaces).
6. For Bluetooth cradles, scan the Pairing bar code on the cradle. Refer to the
User Guide.
IMPORTANT
Connect the USB/host interface cable and power supply (if necessary)
in the order of the steps below to ensure proper operation of the scanner
and cradle.
CAUTION Routing of wiring: All wiring must be protected from strain and routed away
from heat sources and moving parts. The cable must be suitably rated for
exposure to water, oil and grease. All wiring should be appropriately
sleeved to protect it from exposure to water, oil and grease when mounted
on a fork lift.
NOTE The host port is a maintenance port for the scanner, and can only be used for
an ActiveSync connection.
USB/Host Port
Power Port