Reference guide

Quick Reference Guide 3
Introduction
The STB20XX cordless scanner cradles act as chargers and host communication
interfaces for the MT2000 Series cordless scanners. Cradles can sit on a desktop,
mount on a wall or mount on a forklift (STB2000-F only). This document provides
basic instructions for cradle set up and use. Unless otherwise noted, “cradle”
refers to all configurations of the single slot cradle. Any discussion of transmission
of information refers specifically to cradles with Bluetooth technology.
Configurations
Accessories
The following equipment may be needed:
For the STB2000/STB2078 cradle:
• Power supply for desk/wall mounting configuration. See Power Supply on
page 18 for details.
• If applicable, three screws, depending on the surface, for wall mounting (not
available from Zebra).
For the STB2000-F cradle:
• Mounting bracket (provided).
• Power supply for forklift configuration. See Power Supply on page 18 for details.
• Three 8-32 x 1.25 in. screws to fasten the cradle to the bracket (provided).
• Four screws to fasten bracket to mounting surface (not available from Zebra).
Cradle Configuration
Description
STB2000 Single slot, charge only.
Charge only cradles can communicate with a PC via
ActiveSync by attaching a USB cable to the USB connector
(see Connections on page 7).
Note: The USB port is used for service and maintenance
only.
STB2078 Single slot, multi-interface with Bluetooth technology.
Bluetooth cradles receive data from the scanner via a
Bluetooth radio and send the data to the host through an
attached cable (see Connections on page 7).
STB2000-F Forklift single slot, charge only.