Reference guide

10 STB20XX Single Slot Cradles
Mounting the STB2000-F on the Forklift
1. Consult an environmental health and safety
manager to determine an appropriate
mounting location within the recommended
15 in. reach envelope.
2. Ensure the Wall Mount Conversion Dial is in
the correct position (see Caution on page 6).
3. Attach the host and power cables to the
appropriate ports (see
Connections on page 7).
4. Position the cradle with the screw holes in the
cradle aligning with the holes in the isolators.
5. Attach the cradle to the bracket using three
8-32 x 1.25 in. Phillips screws through the
cradle and isolator holes.
6. Mark the mounting surface through the four
screw holes on the mounting bracket, or use
the mounting template to determine the
location of the screw holes.
7. Pre-drill holes into the mounting surface to
accommodate four 1/4-20, minimum 1.0 in.
length, Phillips head screws.
8. If desired, thread cable ties through the holes
on each side of the bracket and secure the
host and power cables along the edges of the
bracket.
9. Attach the bracket to the mounting surface.
10.Place the scanner in the cradle (see Inserting
the Scanner in the Cradle on page 11).
15 in.
Radius
Side View, Standing
Top View
Side View, Seated
Reach Envelope
15 in. Radius
15 in.
Radius