User`s guide

10 SAC5070 8-Bay Battery Charger
Troubleshooting
The Power LED does not light
• Make sure the Power plug of Power Supply Unit is plugged into a wall outlet
and the connector on the end of the Power Supply Cable is snapped in the
Charger’s power connector.
• Plug the Power plug of Power Supply Unit into another outlet.
• Replace Power Supply Unit.
• Contact service representative.
The battery takes too long to recharge
• Ensure that room/battery temperatures are within charging range +32 ºF to
+104 ºF (0 ºC to +40 ºC)
• Clean the contacts on the battery.
• Try another battery to make sure the Charger functions properly. (If the charge
time is more than 4 hours the Charge Status LED flashes red/green).
• Contact service representative.
LED flashes Red/Green
• Remove and re-insert the battery into the charging bay.
• Check for dirt on battery charging contacts and/or charging bay contacts.
• Replace battery with a new one.
• Call service representative.
Regulatory Information
This device is approved under the Enterprise Mobility business of Motorola, Inc.
("Motorola").
This guide applies to Model Number SAC5070.
All Motorola devices are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required.
All Motorola devices are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required.
Local language translations are available at the following web site:
www.motorola.com/enterprisemobility/support
.
72-11589-01.book Page 10 Monday, October 19, 2009 9:22 AM