User guide

Diagnostics
D2119 Dart RTLS User Guide 93
grouping and average tag reception rates. The Hub software lists inconsistencies as islands
within a virtual group.
 Battery status of Reference tags: Shows the battery level and indicates if the battery is low.
You can control the following System test parameters:
 Tags: Select All Reference Tags, Tag List or All Tags to determine what rate of tags each
Receiver detects.
 Receivers: Select All RTLS Receivers, a specific RTLS Receiver List, or a Receiver List
associated with a specific virtual group.
 Timer: Set a time (15, 30, or 60 seconds) or turn off to allow an un-timed test. You use the
Start and Stop buttons to initiate or halt a test.
 Threshold: Set the value for good and bad receive rates for reference tags.
To run a timed test:
1 Start the Hub Administration and Management application, click Diagnostics.
2 In the Diagnostics view, on the System Test tab, from the Tags and Receivers lists, select
the reference tags and receivers for which you want to run the test.
3 Optionally, from the Timer list, select a time or select Off.
4 Click Start to run the test.
5 When the test is done, click Save Results to save the information to a text file for later
reference.