User guide

Diagnostics
D2119 Dart RTLS User Guide 92
Total tags = 18.
To run a timed test:
1 Start the Hub Administration and Management application, click Diagnostics.
2 In the Diagnostics view, on the Receiver Test tab, from the Rx # list inside Receiver section,
select the receiver for which you want to run the test, or select All to include all receivers.
3 Optionally, from the Timer list in Timer section, select a particular time or select Off.
4 Click Start to run the test.
5 When the test is done, click Save Results to save the information to a text file for later
reference
System test
The System Test helps you validate that the timing for computations of all enabled virtual
groups is complete. It provides statistics about detected receivers and tags and lets you
determine optimal receiver and reference tag groupings based on received transmissions from
specified UWB tags.
Similar to the Receiver test (on page 91), you can time the System test or run it manually.
The System test reports information on:
 Reference tags: Shows the average tag reception rates for each receiver.
 RTLS receivers: Identifies timing consistencies and inconsistencies based on reference tag