User guide

Hub administration
D2119 Dart RTLS User Guide 68
control password used for logging in (as administrator or operator).
To configure the system to enable reference suspension protection:
1 Start Hub Administration and Management application, click Administration.
2 In the Administration view, select the Advanced tab
3 Check or uncheck Confirmation on Critical Change box to enable or disable reference
suspension protection.
4 If System Access control is set to ‘Sign-In Based Access’ then configuration change can be
password protected. Check or un-check Password Required on Confirmation to enable or
disable password confirmation on critical change. Changing on Password Required on
Confirmation selection also requires password confirmation. Enter the password when
prompted. Password entered should be the same as the one used for current user log-in.
5 Click Save for the user settings to take effect.
After Confirmation on Critical Changes is selected, accepting any changes that cause firmware
restart will require user explicit confirmation. If Suspend Reference Tag is not enabled at the
time, then a confirmation message box is shown which looks as follows: