User guide

Hub administration
D2119 Dart RTLS User Guide 60
the hub via SNMP. The value 0.0.0.0 represents any host.
 Permission: The permission type granted to the specified community, which can be any
of the following:
None—Does not allow any operations.
Read only—Allows specified community to get information from the Hub.
Read Write—Allows getting information from and setting information on the Hub.
Notify—Allows SNMP trap notifications to be sent to the community on the host
specified via IP Address.
4 Repeat Steps 2 and 3 for all communities.
5 Click Save for the community settings to take effect.
Configuring SNMPv3 users
All SNMPv3 users must be authenticated before they access the SNMP MIB. SNMPv3 only
supports the authentication algorithm MD5 (Message Digest 5 authentication).
To configure SNMP v3 users:
1 Start Hub Administration and Management application, click Administration.
2 In the Administration view, on the SNMP tab, in the SNMP v3 User table, right-click a row
and select Add to add a user (optional).
To delete a user, right-click the respective row and select Remove.
3 To modify a setting for a user, double-click the respective cell in the user row; to complete
the edit, press Enter or click any other table cell.
 Name: The user name
 Authentication Password: The password for user authentication
 Privacy Type: The protocol type to be used for SNMP communication protection, which
can be any of the following:
None—No protection
DES—Data Encryption Standard
 Privacy Password: The password for deriving encryption keys
 Permission: The operation permissions granted to the user:
None—Does not allow any operations.
Read Only—Allows operations to get information from the Dart II Hub.
Read Write—Allow getting information from and set information to the Dart II Hub.
4 Repeat Steps 2 and 3 for all users
5 Click Save for the user settings to take effect.