User guide

Configuring Dart RTLS
D2119 Dart RTLS User Guide 38
and top right corners) by right-clicking on the table header or table rows, and selecting
Append or Insert; then click Auto to generate the remaining vertices of the rectangle.
Click Save to save the input X-Y bounds; then click Exit to close the dialog box.
For a differently shaped area, right-click on the table header or table rows, and select
Append or Insert, enter the vertices, and click Save; then click Exit. To remove a vertex,
right-click and select Remove.
Double-clicking a table cell for Z-Bound starts editing. Enter values in the format of
“min, max”. Typically, min is the smallest z coordinate value set for the Receiver
positions, and max is the largest z coordinate value set for the Receiver positions.
 RTLS Receiver List: Enter the Rx #, range from 01 to FF, of each Receiver to be associated
with the Virtual Group, separated by a space. Alternatively, to add all enabled Receivers
to the virtual group, type ALL in the RTLS Receiver List field.
 Compute Type: Select one of the following compute types to be used for computing
information:
1D Only—Select if you want the system to perform 1-D calculations when two Receivers
detect the tag transmission. 1D-Only virtual groups permit only two RTLS Receivers.
2D Only—Select if you want the system to perform 2-D calculations when three or more
RTLS Receivers detect the tag transmission. For accurate 2D calculations, the entire X-Y
space to track must be surrounded by receivers and the X-Y distances need to be
relatively equivalent.
3D Only—Select if you want the system to perform 3-D calculations when four or more
RTLS Receivers detect the tag transmission. For accurate 3D calculations, the entire X-Y-