User guide

Configuring Dart RTLS
D2119 Dart RTLS User Guide 32
To establish a user-defined coordinate system:
1 Choose an origin (0, 0, 0) point.
2 Measure the (x, y, z) coordinates of each Receiver from the (0, 0, 0) point. Make
measurements to the front of the antenna.
3 Measure the (x, y, z) position of the reference tag from the (0, 0, 0) point.
Configuring Receivers
Next, you need to define the location of each active Receiver within the system. Each receiver
can be configured to be one of the following types:
 RTLS Receivers: Provide tag detection information to be used in locate events. When a
locate event is unavailable, you can configure an RTLS Receiver to provide presence data.
 Proximity Receivers: Provide only presence detections. The Read Range setting lets you
control the Sensor's range.
 Receiver Repeaters: A UWC-1400-R Receiver Repeater is used in applications where cable
lengths greater than 1000’ are needed. The UWC_1400-R is recognized and managed by the
hub but it does not detect UWB tags. On the hub, the repeater should be configured as a
Proximity Receiver.
To configure Receivers:
1 In the Hub Administration and Management application, click Configuration.