User guide

Appendix B: Diagnostics Output Data (D-packets)
D2119 Dart RTLS User Guide 122
Remote Hub Connections
succeeded
 Description: An attempt to connect to a remote hub succeeded at UNIX time
of <timestamp>.
 Recommended Action: None.
 Message Type: This event packet will be sent once when an attempt to connect
with the remote hub succeeds.
 Message Format:
Dart: D,0,0,0,0,0,timestamp,DpacketID,‘ Remote hub connection succeeded’
Hub Sync 100M Clock error
 Description: Clock sync failed between hubs that share receivers, at UNIX
time of <timestamp>.
 Recommended Action: Check the RJ45 cable between hubs are connected in a
daisy chain. There can by only one master hub supplying the clock in a chain of
connected hubs.
 Message Type: This event packet will be sent every minute until clock sync is
established between hubs.
 Message Format:
Dart: D,0,0,0,0,0,timestamp,DpacketID,‘ Error: Hub sync 100M clock error’
Hub Sync 100M clock good
 Description: Clock sync OK between hubs that share receivers, at UNIX time
of <timestamp>.
 Recommended Action: None.
 Message Type: This event packet will be sent once when clock sync is
established between hubs.
 Message Format:
Dart: D,0,0,0,0,0,timestamp,DpacketID,‘ Hub sync 100M clock good’
D-packet event messages
D-Packet
D-packet ID
Message Type
Continuous Message?
No Receiver enabled
-10
Error

No reference tag enabled
-20
Error
Reference tag battery low
-22
Warning

Reference tag battery OK
22
Status
No virtual group enabled
-30
Error
No Receiver detected
-11
Error

No Receiver activated
-12
Error

Enabled Receiver detected
13
Status
Enabled Receiver not detected
-13
Error
Unknown Receiver detected
-14
Warning
Unknown Receiver removed
14
Status
Receiver 00 detected
-15
Warning
Receiver does not see the reference tag
-16
Warning
Receiver has detected reference tag
16
Status
Reference tag detected
21
Status
Reference tag lost
-21
Error
Reference tag not found
-23
Error

Active Receiver communication lost
-17
Error