Quick Start Guide
Table Of Contents
RFD40 RFID Sled Quick Start Guide
5
Inserting the Battery
To install the battery:
1. Align the battery with the notch facing the back of the device.
2. Slide the battery into the handle of the device.
3. Snap the battery into place.
Device Installation
Inserting the TC20 into the RFD40 Sled
To secure the TC20 Mobile Computer to the RFD40 Sled, place the TC20 fully forward on the RFD40 sled base and push
the TC20 down into the Retention Clips.
NOTE Fully charge the RFD40 RFID Sled before initial use.