Product Manual

Appendix A: Regulatory for Third Party Integration
31
• The OEM must professionally install the RE40 into its final environment to ensure that the conditions
are met.
Statement of Compliance
Zebra hereby declares that this radio equipment is in compliance with Directives, 2014/53/EU and
2011/65/EU.
The full text of the EU Declaration of Conformity is available at the following internet address:
www.zebra.com/doc.
OEM/Host Manufacturer Responsibilities
OEM/Host manufacturers are ultimately responsible for the compliance of the Host and Module. The final
product must be reassessed against all the essential requirements of the RED before it can be placed on
the EU market. This includes reassessing the transmitter module for compliance with the Radio and EMF
essential requirements of the RED. This module must not be incorporated into any other device or system
without retesting for compliance as multi-radio and
combined equipment.
In all cases assessment of the final product must be met against the Essential requirements of the RE
Directive Articles 3.1(a) and (b), safety and EMC respectively, as well as any relevant Article 3.3
requirements.
1. The patch antenna (gain: 6 dBi) AN480 was verified in the conformity testing, and for compliance
the antenna shall not be modified.
2. The loop antenna (gain: -30 dBi) P1092482-01 was verified in the conformity testing, and for
compliance the antenna shall not be modified.
3. A separate approval is required for all other operating configurations, including different antenna
configurations (antenna gain increase or different antenna type).
5. If any other simultaneous transmission radio is installed in the host platform together with this module,
or above restrictions cannot be kept, a separate RF exposure assessment and CE equipment
certification is required.