User manual

3
Summary of Firmware Release
V68.19.7Z
03/24/2014 P1040502-017
Issues Corrected
• Bluetooth passwords can now be up to 16 characters long.
• Line mode in CPCL corrected so that it does not require a carriage return/line feed after
barcode fields.
• The SetGetDo command device.macro_get was corrected to support pre-pending
and post-pending .
• Bluetooth radio now supports interaction with devices that use credit-based flow control.
• The SetGetDo command "input.capture" "run" now captures all incoming data.
• Bluetooth radio performance enhanced to support out of order packet streams.
device.syslog.clear_log Clears the local syslog file.
wlan.poor_signal_threshold Controls when the printer indicates it is
receiving a poor signal.
Range:  to 100
Default: 0
ip.tcp.nagle_algorithm Controls the Nagle algorithm.
Default: "enable"
See RFC 896 for further details:
http://tools.ietf.org/html/rfc896
power.inactivity_timeout Now supports "up" and "down" values,
for use in menus.
display.password.current Specifies the current password on
QLn420 and Qln HC printers
Choices: 0 to 9999
display.password.length Specifies the length of the display
password on QLn420 and QLn HC
printers
Choices: 1 to 20
display.status_bar_suppress Temporarily suppresses the status bar.
Choices: off, on
Default: off
display.suppress_all_alerts Temporarily suppresses alerts.
Choices: off, on
Default: off
display.suppress_all_alerts Controls the display of alerts.
Choices: off, on
Default: off
display.root_wml Controls which index.wml file to use:
For QLn220 and QLn320 units, the
default value is "INDEX320.WML"
For QLn420 and QLn HC units, the
default value is "INDEX420.WML"