User manual

Summary of Firmware Release

V68.16.2ZA

P1040502-017 03/24/2014

• CPCL: Print redirection not working when run from a startup file

• Ethernet: DHCP fails on soft reset when docked

• 802.11: Application corruption when mirroring

• 802.11: WEP-128 requires all four keys to be set, should only need one

• 802.11: IP roam packets not sent if WEP-128 is used

• 802.11: Roaming thresholds using incorrect values, see note below

• 802.11: Updated roaming related default values, see note below

• 802.11: “Loss of Signal” alert messages are too aggressive

• 802.11: In range roaming based on signal strength does not work

• WML: Unable to display full Latin character set using custom WML files

After loading this release it is necessary to send the following commands to the printer in order

to update the default roaming values:

Note that a carriage return and line feed are required after each line.

V68.16.2ZA

(Service Pack)

Release Date: 5 August 2011

Enhancements

• N/A

Issues Corrected

• HW: incorrect media width sensor operation

• COMM: Serial and USB port lockup after 1020 labels on QLn220 only

• CPCL: QLn responding incorrectly in CPCL synchronous mode

! U1 do "device.restore _ defaults" "wlan"

! U1 do "device.reset" ""