User manual

Summary of Firmware Release
V68.16.2ZA
18
P1040502-015 05/09/2013
After loading this release it is necessary to send the following commands to the printer in order
to update the default roaming values:
Note that a carriage return and line feed are required after each line.
V68.16.2ZA
(Service Pack)
Release Date: 5 August 2011
Enhancements
• N/A
Issues Corrected
• HW: incorrect media width sensor operation
• COMM: Serial and USB port lockup after 1020 labels on QLn220 only
• CPCL: QLn responding incorrectly in CPCL synchronous mode
V68.16.2Z
Release Date: 5 August 2011
Enhancements
N/A
Issues Corrected
• PRINT: Feed key does not perform PRESENT-AT
• CPCL: TYPE command does not respond when file does not exist
• 802.11: Roaming does not work when using WEP encryption
• 802.11: IP roam packets sent out before DHCP request
• 802.11: Channels mask does not work for channels 12 – 14
! U1 do "device.restore _ defaults" "wlan"
! U1 do "device.reset" ""