User`s guide

Zebra Mobile Printers • Wireless Conﬁguration Guide • rev. H 8

Wireless Network Printer Setup With WLAN 802.11b Radio

continued

You will need information for the Network you will connect to. It

will be useful if you get this information before you start the setup

procedure. Refer to the information you compiled in Table 1 when

completing the set-up process.

NETWORK SETUP USING LABEL VISTA

Label Vista has Network setup wizards to help the user to conﬁg-

ure his/her wireless network printer quickly and easily.

The three types of setup are:

• Quick Network Setup (no Encryption)

• Network Setup with Encryption

• POP3 Setup

Label Vista will also allow you to set the Authentication settings.

QUICK NETWORK SETUP

Use this option if you do not need to use data encryption on your

wireless network.

Once your printer is connected via cable to your PC, open Label

Vista. Ensure that communications to the printer is set per the

preceding section. To verify communication between your PC and

the printer click on Printer/ Read ﬁles. If there is communication, a

window showing the ﬁles in the printer memory will be displayed

after a few seconds.

• Open Label Vista and select “Printer” on the top bar menu. On

the drop down menu, go to Network Setup. Then select: Quick

Network Setup.

• Follow the prompts provided by the set up Wizard, using the in

formation ﬁlled in on Table 1.

• At the end of the setup process you will be prompted to click on

“Test Settings” to make sure the connection and settings have

been established. After selecting “Test Settings” you will see

actual communication between the printer and Access Point tak-