User`s guide

Zebra Mobile Printers • Wireless Configuration Guide • rev. H 55
Type the following in the terminal window in HyperTerminal
and terminate with a carriage return:
! U1 DIR
If you are connected correctly you will see a file listing
containing the three certificate files stored earlier. The
following is an example. The files you see may be different:
Directory
_DEVPROP.PRF 557
ZPL_CFG .CFG 76
TIMSTAMP.PRF 169
CUSTOM0 .PRF 55
INFO .MSP 8634
_WEPCFG .WKF 2
_AUTORUN.PRF 48
DEFAUL~1.XML 17193
INDEX .WML 4777
CACERTSV.NRD 1480
_LOCAL .PRF 73
IP .LBL 99
908000 Bytes Free
Type each of the following command strings and terminate
each with a carriage return. The fields in blue italics will be
unique to your network and printer:
! U1 setvar “wlan.essid” “MyESSID”
! U1 setvar “wlan.8021x.authentication” “peap”
! U1 setvar “wlan.8021x.eap.username” “MyUsername”
! U1 setvar “wlan.8021x.eap.password” “MyPassword”
! U1 setvar “wlan.8021x.enable” “on”
At this point you are done with the configuration of the printer.
Turn the printer off and then back on to initialize all the settings
for the radio. If your printer has an LCD display you should see
the following messages for a couple of seconds prior to the
regular menu appearing:
Security connection
successful.
Connecting to
security server.
Please wait ...
CONFIGURING THE ACCESS POINT FOR WPA PEAP
AUTHENTICATION
WPA increases security further by using TKIP (Temporal Key
Integrity Protocol) as an encryption scheme instead of WEP. All
the access point settings are the same as described previously
for standard PEAP except for the changes below:
• Set the access point to use a cipher as the encryption mode, and
select TKIP as the cipher type.
• Configure the Authenticated key Management to be mandatory
using WPA.
• The WPA Pre-shared key should be set to ASCII.
CONFIGURING THE PRINTER FOR WPA PEAP AUTHENTICATION
Configure the Zebra mobile printer for WPA PEAP
authentication type by typing the following command strings.
Terminate them with carriage returns. The fields in blue will be
unique to your network and printer.
If you previously configured your printer for standard PEAP,
only the lines in red need to be typed in:
! U1 setvar “wlan.essid” “MyESSID”
! U1 setvar “wlan.wpa.authentication” “peap”