User`s guide

Zebra Mobile Printers • Wireless Configuration Guide • rev. H 54
example we will use the ‘peap’ user that we setup previously).
The certificate file must be in PEM format. It needs to have
a specific filename, and must be stored in the printer’s flash
file system. Copy the following file from the FreeRadius
‘DemoCerts’ folder and place it in a temporary folder. Rename
the certificate file as shown below. The file name is not case
sensitive.
FreeRADIUS.net-Root.crt -> CacertSv.nrd
To configure a Zebra mobile printer we will use Zebra’s
Label Vista utility and a communications application such as
HyperTerminal.
NOTE: Label Vista can be downloaded from
http://www.zebra.com
.
You will also need a serial communications cable to connect
your computer and the mobile printer. Refer to the following
table:
Model Serial Cable p/n
QL 220 Plus
BL16555-1 or
BL17757-000
QL 320 Plus
QL 420 Plus
RW 220
BL17205-1
RW 420
Connect the printer serially to a PC and run Label Vista. Match
the com port setting to the printer (refer to the printer’s 2-key
self test for settings) using Printer/Com Port Setup. Send the
“CacertSv.nrd” file by selecting Printer/Send File and make sure
to check off the “Store to flash file system” option.
To set up the printer to use PEAP a few configuration
parameters need to be edited on the printer. Run
HyperTerminal. Create a connection name and set it to the com
port you are using. Match the com port settings to the printer.
Select File/Properties/Settings/ASCII Setup and check the top
two check boxes in the ASCII Sending section: