User`s guide

Zebra Mobile Printers • Wireless Conﬁguration Guide • rev. H 40

To set up the printer to use EAP-FAST a few conﬁguration pa-

rameters need to be edited on the printer. Run HyperTerminal.

Create a connection name and set it to the com port you are

using. Match the com port settings to the printer. Select File/

Properties/Settings/ASCII Setup and check the top two check

boxes in the ASCII Sending section.

Type the following in the terminal window in HyperTerminal

and terminate with a carriage return:

! U1 DIR

If you are connected correctly you will see a ﬁle listing which

should include the “zebra.pac” ﬁle. The following is an exam-

ple. The ﬁles you see may be different.

! U1 DIR Directory

_DEVPROP.PRF 557

ZPL_CFG .CFG 76

TIMSTAMP.PRF 169

CUSTOM0 .PRF 55

INFO .MSP 8634

_WEPCFG .WKF 2

_AUTORUN.PRF 48

DEFAUL~1.XML 17193

ZEBRA .PAC 296

INDEX .WML 4777

_LOCAL .PRF 73

IP .LBL 99

924000 Bytes Free

Type each of the following command strings and terminate

each with a carriage return. The ﬁelds in blue italics will be

unique to your network and printer:

! U1 setvar “wlan.essid” “MyESSID”

! U1 setvar “wlan.8021x.authentication” “fast”

! U1 setvar “wlan.8021x.eap.username” “

MyUsername”

! U1 setvar “wlan.8021x.eap.password” “MyPassword”

! U1 setvar “wlan.8021x.eap.privkey_password” “

MyCertPassword”

Or if your PAC ﬁle is not password protected:

! U1 setvar “wlan.8021x.eap.privkey_password” “”

! U1 setvar “wlan.8021x.enable” “on”

At this point you are done with the conﬁguration of the printer.

Turn the printer off and then back on to initialize all the settings

for the radio. If your printer has an LCD display you should see

the following for a couple of seconds prior to the regular menu

appearing:

continued