User`s guide

Zebra Mobile Printers • Wireless Conﬁguration Guide • rev. H 4

Table 1: Network Information Needed For Printer Set-up

1. What is your wireless LAN’s ESSID (Extended Service Set

Identiﬁer)?: ____________________________________

2. Does the network supports DHCP (Dynamic Host Conﬁguration

Protocol)?

• YES _______ (If “yes”, proceed to question 3)

• NO______ (If “no”, ﬁll out information below)

1. IP address____:_____:_____:____

2. Subnet Mask:__:_____:____:____

3. Gateway:____:_____:_____:______

3. If the Wireless network has WEP (Wired Equivalent Privacy)

enabled then you need to know if it uses 40 bit or 128 bit WEP

encryption and the encryption keys:

• 40 bit key: __________ ____________

• 128 bit key:

____________________ _________ ___________

• Which encryption key index is your network using (circle

one): 1, 2, 3, 4

4. Authentication Information (not available with Frequency

Hopping [FHSS] radios)

If you are using Cisco’s LEAP authentication scheme you will

need:

• User Name: __________ Password: __________

If you are using the Kerberos authentication scheme you will

need:

• User Name: __________ Realm: __________

• Password: __________ KDC: __________

5. Zebra Mobile Network Printers support POP3 (Post Ofﬁce

Protocol 3) The information you will need to set up POP3 is:

• The IP address of the POP3 server: ____:____:____:_____

• The user name of the POP3 account: _________________

•. The password of the POP3 account: _________________

• You will also need to decide how frequently you want the

printer to check for new e-mail. This is called the poll

frequency.

Poll Frequency: ____________________

Information Needed for Network Conﬁguration

Before you start to conﬁgure your printer for use on a Local Area

Network (LAN), you will need some basic information which will en-

able you to establish the network conﬁguration for your printer.

Use Table 1 opposite as a guide to obtain information on important

networking settings. If you don’t know this information, you should

obtain it from the network administrator.