User`s guide

Zebra Mobile Printers • Wireless Configuration Guide • rev. H 21
ip.http.enable
type: getvar; setvar
setvar choices: “on”, “off”
Default: “on”
getvar example: ! U1 getvar “ip.http.enable”
setvar example: ! U1 setvar “ip.http.enable” “on”
This parameter refers to the HTTP protocol / web sever set-
ting.
ip.lpd.enable
type: getvar; setvar
setvar choices:: “on”, “off”
Default: “on”
getvar example: ! U1 getvar “ip.lpd.enable”
setvar example: ! U1 setvar “ip.lpd.enable” “on”
This parameter refers to the LPD protocol setting. LPD com-
munications from the host should be directed to port 515.
ip.netmask
type: getvar; setvar
setvar choices : Any valid netmask.
Default : “255.255.255.0”
getvar example:
! U1 getvar “ip.netmask”
setvar example: ! U1 setvar “ip.netmask” “255.255.0.0”
This parameter refers to the subnet mask address. This value
is ignored if DHCP is enabled.
ip.ping_remote
type: do
do parameters: ip address; number of times to ping
do example:
! U1 do “ip.ping_remote “10”
This parameter directs the printer to ping a specified address
“x” number of times. The address to be pinged is set by setvar
ip.remote.
wlan.international
type: getvar ,setvar
setvar choices: “on”, “off”
default: “on” for 802.11 FH radios; “off” for 802.11b radios
getvar example:
! U1 getvar “wlan.international_mode”
sevar example:
! U1 setvar “wlan.international_mode” “on”
Setting this parameter “on” allows a printer to operate in
wireless networks with settings different from standard US/
Canada wireless network settings. Setting this parameter
“off” instructs the printer to operate according to US/Canada
wireless network standards. Two radio cards are currently sup-
ported: Symbol Spectrum24 802.11b and Symbol Spectrum24
802.11 Frequency Hopping (FH).
NOTE: This parameter must be set according to the wireless
network infrastructure used. Setting this parameter to “on” for an
802.11b card in a network without active wireless access points
with non US/Canada settings stops the printer from communicat
-
ing via its 802.11b card. Setting this parameter to “on” for 802.11
FH radios causes the printer to take an additional 4 seconds to
initiate the 802.11 FH card.
continued