User`s guide

Zebra Mobile Printers • Wireless Configuration Guide • rev. H 17
Typical 2-Key Reset Report
GENERATED: Selecting this option will also enable authentication.
This option is available for backwards compatibility only and may
not be supported in future editions of the Bluetooth library.
To enable authentication make sure you are using Bluetooth library
version 1.2.3 or higher and select the SETPIN option.
PIN
Enter your desired PIN in this box. You can use between 4 and
10 characters and any combination of letters and numbers (ASCII
characters) is allowed. (See SETPIN option above.) NOTE: This
feature is available only when application software is at revision
“44u” or higher.
DISCOVERABLE
Discoverable is set ON or OFF. If Discoverable is turned OFF, the
printer will not be discovered by any other device but can still
can be connected if the application developer knows the printer’s
Bluetooth address. The printer’s Bluetooth address can be found
by printing a Configuration Label (2-key report), or by scrolling
through the LCD if available. (Refer to pg. 9 of this manual or the
printer’s User’s Guide for instructions on printing a Configuration
Label.)
FRIENDLY NAME
The “Friendly Name” is the name that a master device will see
when the printer is discovered. By default, the friendly name is
the printer’s serial number. It can be changed to whatever name
the end user desires.
The picture opposite shows a Configuration Label (2-key report)
with the Bluetooth configurable settings highlighted.
Printer serial number.
Used as Bluetooth
default “friendly
name”.
Discoverable and
Authentication
parameters can be
turned “off.”
Encryption is turned on
when Authentication
parameter is “On.”
Bluetooth Address.
Barcode representing
the address is printed
above. The Bluetooth
address cannot be
changed.
Bluetooth version:
Last 3 digits of the
Software number are its
revision