User guide

PAGE 15 OF 18 0813 IH-2551
π
1-800-295-5510
Introduction
Getting Started
Using the
Printer
Troubleshooting
Accessories
Contact Us
LI72-4 Quad Charger
Accessories
The UCLI72-4 Quad Charger is designed to charge up to four QL
series battery packs simultaneously.
Plug a battery pack into any one of the four charging bays as
shown opposite, noting the orientation of the battery pack. Slide
the battery pack into the charging bay until it stops. Then rock the
battery pack back until it snaps into place. The amber indicator di -
rectly under the battery being charged will turn on if the battery is
properly inserted.
The indicators under the battery will allow you to monitor the
charging process pe
r the table below:
Amber Green
Battery Status
On O Charging
On Flashing
80% charged
(O.K. to use)
O On
Completely
Charged
Flashing O Fault
Notes: For more information refer to the instructions included
with the LI72-4 Quad Charger, or to the more detailed discussion
of the quad charger in the QL Plus User Guide.
The UCLI72-4 Quad Charger has a safety feature which stops
charging a battery after six hours regardless of its charge state.
Fault
Fast C harge
Fault
Fast C harge
Fault
Fast C harge
Ready
Power
Full C harge
Ready
Full C harge
Ready
Full C harge
Full C harge
Fault
Fast C harge
Ready
Charger Bay
Amber
Indicator
Green
Indicator
Power Indicator
Power Supply
1. Slide Battery Pack
into a Charger bay
2. Rock Battery
Pack into place
Quick Start Guide QL Plus Series