User guide
43
QL Plus Series User Guide
Compact Flash (802.11b) and Bluetooth Co-located Radio
Modules
NOTE: The co-located Bluetooth and 802.11b radio option is available
only on units with 4MB Flash/8 MB RAM memory installed. The
memory and wireless options installed on your printer may be
determined by printing a conguration label as detailed on pages
64-68.
The following section only applies when the CF (Compact Flash) WLAN module (
FCC ID: H9PLA4137) and Bluetooth module (FCC ID: I28MD-BTC2TY4) are installed in a QL 220
Plus or QL 420 Plus printer. This co-located radio conguration has demonstrated compliance to
FCC regulations. The FCC ID numbers are on the serial number label on the back of the printer and
can be read with the module installed.
Caution • Use of a QL 220 Plus or QL 420 Plus printer with
the radio module marked with both “FCC ID: H9PLA4137” and
“I28MD-BTC2TY4” meets the FCC requirements for radio frequency
(RF) radiation exposure in the standard body worn conguration with
no minimum separation. In this conguration, which applies whether
the belt clip or shoulder strap is used, the face of the printer from
which paper is transported is facing away from the user’s body. The
standard conguration must always be used when the printer is body
worn. QL 220 Plus and QL 420 Plus printers with this radio option
have been SAR tested. The maximum measured SAR values are listed
below.
Model
SAR value W/Kg (1g average))
QL220 Plus 0.01
QL 420 Plus 0.39
European Regulatory Information for Co-located Radios
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.
continued