User guide
41
QL Plus Series User Guide
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU
and EFTA member states except in France
where restrictive use applies.
Zebra 802.11b WLAN Radio Module
NOTE: The 802.11b radio option is available only on units with 4MB
Flash/8 MB RAM memory installed. The memory and wireless
options installed on your printer may be determined by printing a
conguration label as detailed on pages 64-68.
The following section only applies when the Zebra 802.11b WLAN radio module
(With FCC ID: I28MD-ZLAN11B) is installed in a QL Plus series printer (note that only one of the
radio options can be installed in the printer at one time). Other than conditions specied elsewhere
in this manual, only one of the radio options can be installed in the printer at one time and the
antenna used for these transmitters must not be co-located or must not operate in conjunction with
any other antenna.
QL Plus models have the FCC ID number on a label on the back of the unit.
Caution •
The radiated output power of this internal 802.11b radio
is far below the FCC radio frequency exposure limits. Nevertheless,
this radio must be used in such a manner that the antenna is 2.5 cm.
or further from the human body. The radio and antenna are mounted
internally in this printer such that when the printer is worn with the
back of the printer against the body and the front of the printer (where
paper exits) away from the body, then the 2.5 cm distance between
the antenna and the users body will be met. Do not use the printer in
an unauthorized manner.
European Regulatory Information for this Radio
AT BE CY CZ DK
EE FI FR DE GR
HU IE IT LV LT
LU MT NL PL PT
SK SI ES SE GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (CH, IS, LI, NO)