Specifications
6HFWLRQ 0DLQWHQDQFH
,U'$%RDUGDQG&DEOH5HSODFHPHQW
1. Turn the printer Off (2). Disconnect the battery charger.
2. Slide the battery compartment door open and remove the battery.
3. Lay the printer on a flat surface with the back facing up.
4. Remove the two shoulder strap screws indicated in Figure 4-3 on page 4-8. Set the
shoulder strap, shoulder strap sleeves, and shoulder strap screws aside.
5. Remove the rear cover mounting screws.
6. Lift the rear cover off and set it aside.
7. Refer to Figure 4-19. Unplug the IrDA cable from the IrDA board.
8. If replacing the IrDA board only, slide the IrDA board out of the printer.
9. If replacing the cable, unplug it from the main logic board, and remove it from the
wire clips.
10. Replace the cable by plugging it into the IrDA board.
11. Insert the IrDA board as shown.
12. Dress the IrDA Cable and secure it with the wire clips.
13. Plug the remaining connnector into the main logic board.
14. Replace the rear cover and shoulder strap.
15. Reinstall the battery, load the media, and test the unit. Connect a battery charger if
necessary.
Figure 4-19. Install IrDA Cable and Board
IrDA Cable
IrDA Board
Assembly
Wire Clip
MLB IrDA
Connection
Route the cable as shown.