Specifications

0DLQWHQDQFH 6HFWLRQ
19. Refer to Figure 4-6 on page 4-12. Place the print mechanism, with the media access
door facing down, into the front cover by holding it at the top near the access door.
Slide in the bottom of the print mechanism first.
20. Refer to Figure 4-3 on page 4-8 and replace J2 (motor harness) and J1 (printhead
harness). J2 and J1 are keyed and fit only one way. Do not force them into the
connectors.
21. Refer to Figure 4-8 on page 4-14. Route all harnesses to avoid pinching and screw
posts.
22. Refer to Figure 4-7 on page 4-13. Ensure the battery access door is in the slot in the
front cover with the flat side facing in.
23. Replace the cover and shoulder strap.
24. Install a battery, load the media, and test the unit. Connect a battery charger if
necessary.
Figure 4-17. Membrane Switch Assembly