Specifications

0DLQWHQDQFH 6HFWLRQ
30. Reinstall the printhead assembly by reversing steps 5 through 9. Ensure the 16-pin
connector, 4-pin connector on the ribbon sensor board (PT400 only), two ground
wires, and head-open switch wire are connected to the printhead before operating.
Ensure all connections are fully seated.
31. Close and latch the print mechanism module media access door.
32. Install a battery, load the media, and calibrate the unit. Connect a battery charger if
necessary.
Figure 4-15. Sensor Connector Location
Figure 4-16. Removing the Access Door Top
1RWH7KHUHSODFHPHQWZLULQJKDUQHVVDVVHPEO\LVGHVLJQHGIRUXVHRQERWKWKH
3$[DQG37[$QDGGLWLRQDOJURXQGZLUHOHDGLQJIURPEHQHDWKWKHPHWDOVKLHOG
LQVLGHWKHWRSFRYHUVKRZQLQ)LJXUH RQSDJHLWHPDWWDFKHVWRWKHJURXQG
VFUHZRQWKHSULQWKHDG&RQQHFWWKHDGGLWLRQDOJURXQGZLUHWRWKHJURXQGVFUHZRQWKH
SULQWKHDGZKHQXVLQJWKHZLULQJKDUQHVVRQWKH3$[DQG37[VHH)LJXUH RQ
SDJH
Inner Media Sensor
Outer Media Sensor
Front View Rear View
Access Door Top